wiring

Home Forums MGTD Kit Cars VW Based Kits wiring

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #232221
    Guests
    Participant

    @guests

    i just inherited a fibre fab pre built kit car. it was their factory show room

    model only has 7/10’s of a mile on her. but there is a problem the car

    itself runs great. but none of the gauges work. they light up when the

    head lights are on but do not work. and the hazards are always on. i just

    pulled the fuse to stop that. but any info would help. and thanks again in

    advance

    #236824
    Keith True
    Participant

    @keith-true

    Make sure all the grounds are hooked up and clean,remember everything on a plastic car has to have a ground wire.Also,check that there is juice running all the way through the fuse panel,not just at either end of the fuse.I have 2 of these cars,and like yours they have sat around a lot.I found that resistance would develop between the brass fuse clip and the rivet that holds it on.juice would go through the fuse,but not out the wire.If it was wired correctly to begin with you are going to find a small problem,or a series of them.You can download the assembly manuel for that car on this site.It has the wiring codes explained in it.You should have little tags with #”s on each wire and the book will tell you where it goes.The wiring on these is very simple.

Viewing 2 posts - 1 through 2 (of 2 total)
  • The topic ‘wiring’ is closed to new replies.