This will require photos.

The short tilt wheel release lever found on older car columns fits as a turn signal lever. No modification required.

I do not know the actual backspacing measurements but I run 15 x 7 Mustang police steelies with no issue. My 14 x6 Cragar Truspokes stick out just to the fender edge like the 15’s do. My 14 x 5-1/2 Fairmont steelies ride so far inboard I require wheel spacers to keep them off the suspension parts. Your results may vary as I also have drop s…[Read more]

Done.

All I need now is a car.

oh…

and good weather. Definitely need good weather.

Wow! To have an untouched original still in the box. I am really looking forward to following your build. Again, Wow!

Well, we managed to finish fitting the replacement grille shell. After fitment I took some polishing compound to it.

The cold weather sure makes for slow progress, but progress it is. It’s looking good.

Well, there’s been no activity on this site for well over a week so I guess I’ll post something. We went and ran an autocross. It ran well, but we had a noise. the noise got real loud when the suspension was at it’s collapsed travel. Turns out the bracket I made to hold my parking brake cables was too low and the equalizer was able to hit the rear…[Read more]

Back when mine was a daily driver, I had quarter windows put into my original top. This made it a lot easier to see to back up, change lanes, etc. If you’re going custom, it’s something to consider.

I use a cover I got years ago that was a GM accessory. It was for a Chevy Cavalier. It fits nice and tight with stretch fit over front and rear bumpers.

Rooms can be booked now?