On mine, the rear bow slides into a sleeve sewn into the top. There is an opening in that sleeve near each end where you take that strap and loop it over the rear bow. Then just loop it over the front bar and adjust with the buckle to where the top looks right.

We ran a new 8ga cable and everything works just fine. With everything turned on there is no smoke escaping. So on to fixing the hole in the side panel.

A trip to the local craft store supplied a Styrofoam ball.

Enlarged the hole to allow clearance for further adjustment if ever needed.

Cut a section off the ball and shaped it to resemble…[Read more]

Sorry to hear of your breakdown. I hope it goes easier than it sounds. ☹️

Congratulations on your trophy, though! 👍

Just saw the post.

Congratulations!

Due to some electrical issues at the Weatherly Hillclimb, I thought I’d take a few minutes and upgrade the alternator for the VA Beach trip. Ha! Everything snowballs.

Well, I have a week to get it back together.

It seemed a good idea at the time.

Just over a week to go. Anyone else joining the party?

The Ford Fiberfab build manual on the left here has a wiring diagram in the back. You might find that helpful.