-
Mike Stucky started the topic Help with radio replacement in the forum VW Based Kits 8 months, 2 weeks ago
Hello everyone,
Looking for some help in switching out my old 80’s tape deck to something newer. I know I am going to need to make the hole in the dash a bit bigger, but I am looking for some insight on how to install a bracket in the dash. The old radio is directly attached to the dash, but these new radios require a bracket of some sort. Ju…[Read more]
-
Eppa Wimbish posted an update 8 months, 2 weeks ago
I now have a Dutchess, built about ’92. She is not factory built, but seems fairly well done. She has Chevette front and rear suspension, Ford 2.3 engine, 4 spd… -
Eppa Wimbish accepted an invitation from Paul Mossberg and became a registered member 8 months, 2 weeks ago
-
DALE accepted an invitation from Paul Mossberg and became a registered member 8 months, 2 weeks ago
-
foolthrottle replied to the topic Looking to Buy in Northeast in the forum MGTD Cars WANTED 8 months, 3 weeks ago
Jeff
From your pictures you have only a body and fenders, no chassis or engine? from pictures yours appears to be the VW chassis kit.
-
Jeff and
foolthrottle are now friends 8 months, 3 weeks ago-
Yes I have the body kit no chassis or engine will give someone a good deal
-
-
Jeff replied to the topic Looking to Buy in Northeast in the forum MGTD Cars WANTED 8 months, 3 weeks ago
I have one to part with mgtd still in boxes I am in central pa.
-
Jeff posted an update 8 months, 3 weeks ago
I bought a 1952 mgtd kit car , it’s been stored in a barn for 40 years still in kit form the boxes were in dirty condition . I cleaned everything and seen what I had t… -
Jeff accepted an invitation from Paul Mossberg and became a registered member 8 months, 3 weeks ago
-
SirWilliam accepted an invitation from Paul Mossberg and became a registered member 8 months, 3 weeks ago
-
billnparts replied to the topic New member in the forum VW Based Kits 8 months, 3 weeks ago
It’s quite probable that 1984 was the year the build was completed. I have mine titled as a 1989 for that very reason. Some folks have theirs titled as the year of the donor car, but 1984 counts that out.
Good luck on you acquisition. If it is roadworthy in time, consider the Virginia Beach event.
-
Jerry Christenson replied to the topic New member in the forum VW Based Kits 8 months, 3 weeks ago
Correction: the plate under the hood has the number Fm1002.
-
Jerry Christenson started the topic New member in the forum VW Based Kits 8 months, 3 weeks ago
I purchased a Fiberfab MiGi on June 15th at a local estate auction for $2350. They identified it as a 1984 but I don’t know for sure if that is correct. The Fiberfab plate under the hood has number SN1002. That number was also listed as the VIN on the NC title I received. It had obviously sit outside with a tarp over it for years. The auction f…[Read more]
-
Jerry Christenson posted an update 8 months, 3 weeks ago
I purchased my Fiberfab MiGi on June 15th at a local estate auction for $2350. It was identified as a 1984 but I am not sure what I have. The Fiberfab plate under the hood has the number SN1002 on it. It has obviously been sitting outside with a tarp over it for years. I was able to start it up and drive it home. The number on the VW engine starts…[Read more]
-
Jerry Christenson accepted an invitation from Paul Mossberg and became a registered member 8 months, 3 weeks ago
-
billnparts replied to the topic Wire spoked wheels squeak in the forum General Discussion 8 months, 3 weeks ago
I don’t know what make of wheel you are running, but I have had a set of Cragar Tru-Spokes for over 30 years with very few issues. Certainly not noise.
Perhaps spraying WD-40 or equivalent at the contact points of the spokes might help.
-
Allen started the topic Wire spoked wheels squeak in the forum General Discussion 8 months, 3 weeks ago
I have a 1952 MG Replica with wire spoked wires. After driving for a short period of time, a squeaking sound comes from by wheels that is in unison with wheel rotation. I assume this sound is caused by the spokes criss-crossing each other or where the spokes connect to the rim. Don’t think it is related to the brakes or wheel bearings. Anyone e…[Read more]
-
Stefan started the topic Exhaust in the forum General Discussion 8 months, 4 weeks ago
My exhaust system is rusted and not properly installed on my car. So, I am looking to get a new exhaust for my VW based TD. I am not sure if the TD body makes it harder/impossible to install some systems that would normally fit on a beetle. So, I would like to know what y’all are running 🙂
Also, if anyone has any recommendations for a exhaust…[Read more]
-
Travis replied to the topic BCW Type 52 with V6/5 speed for sale in the forum Running MGTD Kits Cars for Sale 9 months ago
Is this still for sale?
-
Kevin Durkin changed their profile picture 9 months ago
- Load More
