Home › Forums › General Discussion › E-Brake & Shifter swap › E-Brake & Shifter swap
September 11, 2008 at 8:48 pm
#237441
Hi every one, I had the ebrake problem but my car has a one piece seat bottom so I coud not move the ebrake handle behind the shifter.I cut a v shaped section out of the handle,then bent it up and welded it back together, also I bent and shortened the release rod to match .Now the is at a 30 degree angle to the tunnel when completely down. Not a perfect solution but much better then it was.Hope this helps somebody. I am new at computers and forums,Hope I am replying at the right place. Larry Murphy