-
Allen replied to the topic Wire spoked wheels squeak in the forum General Discussion 5 months ago
Thanks for your reply. It forced me to look elsewhere for the source of the squeaking. I discovered that the wheel bearings were the problem. They needed to be tightened. Quiet now.
-
Allen started the topic Wire spoked wheels squeak in the forum General Discussion 6 months ago
I have a 1952 MG Replica with wire spoked wires. After driving for a short period of time, a squeaking sound comes from by wheels that is in unison with wheel rotation. I assume this sound is caused by the spokes criss-crossing each other or where the spokes connect to the rim. Don’t think it is related to the brakes or wheel bearings. Anyone e…[Read more]
-
Allen posted a new activity comment 2 years, 5 months ago
Photo of my right-side wheel hub spinner. 2-winged that came off during a drive and is lost. Looking for a replacement, but having no luck. Anybody have these to sell or know where I could possibly locate one or a set? -
Allen commented on Allen's Photo 2 years, 5 months ago
Photo of my right-side wheel hub spinner. 2-winged that came off during a drive and is lost. Looking for a replacement, but having no luck. Anybody have these to sell or know where I could possibly locate one or a set? -
Allen posted an update 2 years, 5 months ago
-
Photo of my right-side wheel hub spinner. 2-winged that came off during a drive and is lost. Looking for a replacement, but having no luck. Anybody have these to sell or know where I could possibly locate one or a set?
-
-
Allen started the topic Want a Wheel Hub Spinner for MG Replica in the forum Classifieds 2 years, 6 months ago
Looking for a Wheel Hub Spinner for my MG Replica which was lost during a drive. It is a two pointed spinner. Anyone have one or know where I can get one?<span class=”Apple-converted-space”> </span>
-
Allen replied to the topic Ideas for Lining Under Hood in the forum General Discussion 2 years, 11 months ago
See my Posting of my enclosing the open space of the trunk of my VW MG with pictures showing what I did.
Allen -
Allen posted an update 2 years, 11 months ago
My MG Replica did not have an enclosed trunk, so I made one myself using 1/16″ sheets of G-10 fiber glass. However, I made a template out of cardboard first and trimmed until it fit correctly, then used this as my pattern to cut the fiber glass. The Wood knob allows me easily remove the assembly to access the wiring and mechanical linkage. Looks…[Read more]
-
Allen posted an update 2 years, 11 months ago
-
Allen replied to the topic Replacing the BackUp Sensor in the forum General Discussion 2 years, 11 months ago
Thanks for reply. I am assuming it is the switch because the bulb is good. Looks like a tough place to reach and change the switch from the bottom. Wonder if the switch be reached from the inside. Car in storage now and will look inside next time I check the car and follow the wires. Basically a push-buttton configuration type switch. If I cannot…[Read more]
-
Allen started the topic Replacing the BackUp Sensor in the forum General Discussion 2 years, 11 months ago
Is there a proper way to raise the MG to replace the backup sensor? Ramps or jack? I do not want to stress the body connections to the metal frame. I don’t believe there is way to access the sensor from the inside. MG has an air cooled VW engine, if that has any affect on the situation.<span class=”Apple-converted-space”> </span>
-
Allen became a registered member 3 years, 1 month ago
- Load More
