The manual that exists here for the Pinto assembly might offer a point of reference you could use for determining the length you need as both are front engine.

It’s a flat windshield. Any good glass shop can cut you one. Just make sure you’re getting laminated safety glass.

Ok, Roy. You’re on. Ed has registered and I just completed mine. It’ll be good to see you and Jack. Paul? Dale?

OK. those that were there know the edge of the macadam at the show field snagged one of my mufflers and pulled it off. Quick repairs were made on the spot but left me with an exhaust leak. It kept getting worse as we drove home. I figured the pipe was cocked at the header collector but that wasn’t the case. David insisted the #8 header tube weld…[Read more]

You cannot stamp louvers in fiberglass. He will do a panel in aluminum and I will cut out the side panels and graft it into place.

Well, I guess I’ll post the few pictures I took over the weekend.

This was on the way to Carlisle. Trying to run with traffic in the left lane caused it to run a bit hot. I had to keep it under 70.

Thursday afternoon early arrivals.

We had a bit more room at the new hotel. I didn’t even know where the Hospitality room was until…[Read more]