@garywilson
Active 5 months, 3 weeks ago-
Gary Wilson replied to the topic New Member looking for some assistance in registering my FiberFab 1952MGTD in the forum VW Based Kits 5 months, 3 weeks ago
Hello JC
I have been building a Classic Motor Carriage Kit in the State of New York. I have been in contact with the New York State DMV as to the registering of it over the past few years and have a few insights on navigating their requirements. I have not finish my MGTD 52 Replica and plan on contacting the DMV to set an appointment. I would…[Read more]
-
Gary Wilson posted an update 7 years, 4 months ago
@itsmemike Hi mike, i am just starting my ford powered cmc/fiberfab YD. I am interested if the motor mounts on your 2.0 engine were a bolt in fit. I have access to a 71 pinto, also with a 2.0 and four speed. thanks, Gary
-
Gary Wilson replied to the topic Donner Car for a Ford Kit in the forum Chevy/Ford Kits 7 years, 4 months ago
Bill, the pinto (1971) has the engine and transmission, 2.0 and 4 speed that I would like to use.I have had several conversations with NYSDOT (New York State) as to requirements that will allow the car to be titled as a 2018 custom.The emission devices are minimal, PCV and preheated air intake.The newer the doaner car, additional devices…[Read more]
-
Gary Wilson started the topic Donner Car for a Ford Kit in the forum Chevy/Ford Kits 7 years, 4 months ago
My first attempt at posting,I have a CMC kit purchased in 1993. The assembly manual states that a1974-1980 pinto is recommenced.I have access to a 1971 pinto 2.0/4SP will this work.
-
Gary Wilson posted an update 7 years, 4 months ago
My first attempt at posting,I have a CMC kit purchased in 1993. The assembly manual states that a1974-1980 pinto is recommenced.I have access to a 1971 pinto 2.0/4SP will this work.
-
Gary Wilson became a registered member 7 years, 4 months ago
- Load More