Update! Problem appears to be the throttle cable with the plastic tube. Didnt work for me and I wont use on again.

I did post on samba. I’m going to take the car to a friend this weekend.

I think I am going to take it to a friend and see what he can figure out. Talked to one guy who charges 65 an hour. Not going to happen! Wrong economy! I’ll keep on it anyway and thanks to all of you for your help!

Not fixed!!! Dual Empi 34’s. Flamethrower 009 no vacum advance. I set the timing at 0 tds and it ran terrible. Now I adjust it where it sounds right. This engine is not factory and appears to an after market mill or 75 and up FI but not sure. When I push the pedal down the carbs throttle are maxed. The fuel system is clean and I watched the fuel…[Read more]

Im not proud of it yet. I am starting to feel it may be pic worthy!

I have new dual carbs and new heavy duty throttle cable with housing. I adjusted the fuel regulator up to alow more fuel in. no change.

I just ordered a new electronic dist. All the rest have been checked and adjusted.

Is it possible the 009 dist. is not advancing causing it to flatten out at 55?

most of it is new. will be going over it tomarrow.

Hey thanks everyone for the info!

OK top is holding so far. I used a metal bar from cyclone fence as well as adjusting the top.

He was used as a CI then they had evidence. At least enough to make a charge. Guess his info was more valuble to them. Glad no one was hurt! Like the story!

The plexi came with the top but my feeling is that its too flimsy. I will try the aluminum though. I just finished adjusting the top and now I have to move the screw snaps. I’m going to be filling hole forever. I will drive it tomorrow and see what happens. 

The front edge has a plexiglass insert but the top is loose above my head. I will look at the bow for adjustments and see what happens. Thank you!

Thank You for the info.

Would those side mirrors fit my fiberfab windshield frame? If so where should I get them?

Wiper blades and arms worked out great.

Murphy! Thank you. Going to the parts store tomarrow.

Good job on the shift rod. Transmissions in the vw are pretty durable and a used one can be found cheep with a little looking. You could also put yours in the shop. That should be cheep to rebuild.

No luck yet. I have a friend thats going to take a look at the car to see if he can solve my delima.