-
Dale Borthwick became a registered member 6 years, 9 months ago
-
billnparts started the topic Pagoda Hillclimb 2019 in the forum Clubs and Show 6 years, 9 months ago
Carlisle this year was a shakedown run for the TDr8. The heat issue was identified and plans are currently underway to install real louvers in the side panels to extract the heat.
Moving on to the Pagoda Hillclimb.
Pulled the safety cage out and washed it.
I had ordered permanent numbers for the car, so they were finally installed.
The…[Read more]
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
billnparts added a Photo 6 years, 9 months ago
-
Marty became a registered member 6 years, 9 months ago
-
billnparts replied to the topic steering column in the forum General Discussion 6 years, 9 months ago
The manual that exists here for the Pinto assembly might offer a point of reference you could use for determining the length you need as both are front engine.
-
edward ericson replied to the topic steering column in the forum General Discussion 6 years, 9 months ago
That is a truly good question. Wish I knew the answer. No one has yet uploaded an assembly manual for a Chevette-based kit. I doubt anyone here ever knew Chevettes came with more than one length of steering column…
Speaking on general principle I’d get the “standard” length or the longest available, since it’s easier to cut one down if…[Read more]
- Load More
