[william Bennett]

Car is Sold

[william Bennett]

The car is Sold.   Thanks to everyone who have helped me on this project.  Bill

[william Bennett]

Hi:  I am at the point of just fitting fenders for the first time.  One of the main supports on my ford TD are the short front bumper  extensions.  They are slotted and can be angled to point up or down slightly.  If you can post a few pictures that would help.

[william Bennett]

Thanks for the reply’s.  The picture helps allot.  I also picked up a pair of the original TD Head Light brackets and now see how the bar is used at the inboard ends.   I am still in the process of fitting fiberglass panels which will take awhile.

[william Bennett]

Thanks for the answers:  My fiberglass liner is cut out in the middle to allow air to flow.  If it’s to support the headlight brackets I may modify it to fit better and only use a portion to support the head lites or use the bar method and do away with it all together.  Thanks again  Bill

[william Bennett]

Sorry,  I sold them on EBAY

[william Bennett]

Bill:  Looks like they are truly zero offset.  6″ rim with 3″ backspace

[william Bennett]

Thanks Bill  I am quite a ways off from mounting my seats but the information helps.

[william Bennett]

Allen:  Thanks for the information.  My kit is pinto based and I only viewed that manual.  A quick glance and the VW manual has more information than the ford manual I received with the car. I will be reading the VW manual tonight.  Thank Again  Bill

[william Bennett]

Thanks Allen,  I will mark it as such.  None of the fiberglass is mounted yet, but it seems right.  Good luck with your build.  Bill

[william Bennett]

OK so I don’t have this picture thing completely figured out yet.  The 2 square plates are approx 4″ x 4″.  and the angle is about 15″ long.  everything is around 3/16 thick.   thanks Bill

[Author]

Posts