Forum Replies Created
-
Posts
-
I went to a tons house in lake lure.nc he showed me his lafer and his speedster.both very nice cars
Thank you Dave .present already delivered.you and your family have a wonderful christmas.and happy new year.you should help Santa deliver presents in thar beautiful green td r
if you want I have some pics I took of the actual hitch and how its bolted under the bumper brackets, I don’t want to try and down load them on here so if u want ill email them to you , send me message in im with your email address ill send them to you.
See the blacks angle iron behind bumper that is bolted to the frame where bumper brackets bolt.the the tube where the receiver slide in is welded to that .a bracket on top of tube is bolted to the bumper in middle.mine has a steel support inside bumper which made it very easy to bolt center support to.I used all steel harden bolts .I have pulled a motor cycle trailer whit my Harley ultra classic on it had no problems.
ok not sure if I did it right tried to download pictures of receiver hitch a couple went but not the ones I wanted to download , sorry ill get it right sooner or later
I thank before I put them in running board.I would go to motor cycle shop or boat shop and buy the cup holders that,swivel and screw the to center bottom of dash would look good be up and out of way and you wouldn’t mess up your td or devalue it. I am going to go to Lowe’s buy some nice would and make on to match dash and put it between seats.
thank you for the help ill learn someday I guess, computors or not my strong point. the carpet in my car is actually brown but just looked black,i got it from mg majic
To much stuff just to load a picture sorry about that I thought i,was sending them were they were suppose to go .I checked and they were in my albun.but any way to much go here push here do this do that.I’ll cease from downloading pics.
I will take some pic of dash for you smitty. Also will take some of NEw carpet .but dash is nothing special.standard wood dash with chrome gauges
No I didn’t all sanding was done by hand and the buffing was done with a button buffer.places I could not net with the buffer I buff by hand.the buffing process is a real job.in some areas I had to buff redan it and buff .alot of buffing until u get the desired result.it takes alot of time and patients
It’s alot of work bringing gel coat back from the dead but it’s worth it as long as you don’t have chips or deep scratch that go all the way down to the fiber glass.if you take your time use emery cloth .I started out with 700 grit then 1000.then 1500 then 2500.finished with 3000 grit.then buffed it with number mirrow glaze number1.finished it with number 2.then waxed with a really good wax. Make sure you soak emery cloth in water for about an hour before you start sanding and keep it wet while you sand.
I would put some small bucket seats in it .plenty of small cars out there with nice bucket seats
yea I am going to take it out clean it Saturday and I will take pics of inside with top down so the new carpet can be seen
No I didn’t repaint car that is the orginal clear coat.car was almost pink and had bubbles in paint and faded allover.I water sanded car with 5 different grades of sand paper.finishing up with 3000grit .that took 3 weeks everyday for about 5 hrs a day.then 4 days of buffing out paint.and eND results was better and cheaper than a repaint.plus it is original factory clear coat.
