-
Steve Struchen replied to the topic Nice, but what a price! in the forum Running MGTD Kits Cars for Sale 10 years, 9 months ago
I wonder what those bucket seats are from. Snug fit in the cockpit but they seem to work.
-
Steve Struchen replied to the topic Nice, but what a price! in the forum Running MGTD Kits Cars for Sale 10 years, 9 months ago
Is it really powered by the quite rare VW V4 engine?
ALARM SYSTEM?… Wonder how that works.mustang_evets2014-02-04 15:55:07
-
Steve Struchen replied to the topic fun reading about TD;s in the forum General Discussion 10 years, 9 months ago
You might stop at a Subaru Dealership too and see what their reaction is.
-
Steve Struchen replied to the topic Recent TDr site outage in the forum General Discussion 10 years, 9 months ago
OMG the withdrawal I was suffering. I really missed the site being up.
-
Steve Struchen replied to the topic What brake system are you running on your TDr? in the forum VW Based Kits 10 years, 9 months ago
What do you do for the speedometer drive when you put front discs on? Is there a provision for retaining the speedometer cable?
-
Steve Struchen replied to the topic Grille Badges? – We don't need no stinkin badges in the forum General Discussion 10 years, 9 months ago
Bill responded right away. He did say I should send the payment and order to the address that is listed.
Thanks Paul, my order is in the mail to Bill. -
Steve Struchen replied to the topic Engine Dropped in the forum VW Based Kits 10 years, 9 months ago
Yes, that is the same style as the Truck one I listed below. It looks like the one you show has two sockets in inch sizes, that looks like the only difference I can see other than the price.There are two different sizes available. I purchased both of them.
The lighter weight one for Auto use ($44.50) is the one I tried. It is an 18:1 reduction ra… -
Steve Struchen replied to the topic Engine Dropped in the forum VW Based Kits 10 years, 9 months ago
AllenI just got a torque multiplier that I ordered on eBay after reading your post. Wow, does it work great. Thanks for the “heads up” on this tool. -
Steve Struchen replied to the topic Grille Badges? – We don't need no stinkin badges in the forum General Discussion 10 years, 9 months ago
Oops,my bad. I did send an email rather than PM.
I’ll post what I hear back from him when I hear from him. -
Steve Struchen replied to the topic Grille Badges? – We don't need no stinkin badges in the forum General Discussion 10 years, 9 months ago
Thanks Paul.
I have sent a PM to Bill -
Steve Struchen replied to the topic Soob swap in the forum VW Based Kits 10 years, 10 months ago
Don’t give up. It can be done. Just imagine how sweet it will be when finished.
-
Steve Struchen replied to the topic Soob swap in the forum VW Based Kits 10 years, 10 months ago
It’s hard to believe we need all those wire to make it run isn’t it? Oh well, where is the challenge in simply running a hot wire to a coil?
I was thinking of running the wires in clear tubing and adding some LEDs randomly throughout the harness. -
Steve Struchen replied to the topic Whose VW TDr is this? in the forum VW Based Kits 10 years, 10 months ago
Mine is 25010
-
Steve Struchen replied to the topic Soob swap in the forum VW Based Kits 10 years, 10 months ago
I have found that I can buy 10′ outdoor antenna mast pipes that are 1.25″ od, 1.125 id.I have a Harbor Freight rolling wheel that I have upgraded with kits from Swag Off Road. I am going to try to bend that pipe to conform to the outside edge of the VW pan and thus route the radiator lines within the heat channel area.Finally got the engine a… -
Steve Struchen replied to the topic Soob swap in the forum VW Based Kits 10 years, 10 months ago
You wouldn’t try licking that mount here in Iowa today because your tongue would be stuck to the metal.
It is 0*F here now.:| -
Steve Struchen replied to the topic Added weight on FiberFab kit in the forum VW Based Kits 10 years, 10 months ago
+1 for what edsnova said.
-
Steve Struchen replied to the topic Building Alfred in the forum My Project 10 years, 10 months ago
I stand corrected.
I am used to buying tires by their wheel diameter so that is my excuse and I am sticking to it.😡 -
Steve Struchen replied to the topic Building Alfred in the forum My Project 10 years, 11 months ago
24″ tires? I’m thinking it more like 14″.
-
Steve Struchen replied to the topic In want of a windshield in the forum Chevy/Ford Parts Wanted 10 years, 11 months ago
The use of the original supports for the corners will require tub modification to get them to fit. The TD Replicas have those flat areas molded into the tub so you can attach the extended sides of the windshield frame. You would have to grind them off and then reinforce that area to be able to mount them.
The pieces you have shown would make the… -
Steve Struchen replied to the topic intro in the forum Membership 10 years, 11 months ago
Welcome to the site.
There are loads of informed people here who are happy to give their insight into problems you may have with the kit construction. Some of it is even good advice. 🙂 You just have to figure out which it is.Try the search function in the Forum area. It has loads of good information in it. The “Download Manuals” area is good t… - Load More