North Hollywood Speed shop in California ir Dick’s Speed & Tach in Tempe (Phoenix), Arizona are two of the remaining repair shops.

No I didn’t. This morning the numbers in the odometer were 30997. The 0 and both 9’s were out of sink. I took it off for a ride and all four numbers on the right had to rotate. All the numbers are now in decent alignment . One of the 9’s is off. So I’m going to keep this speedometer. Hopefully in time it will correct itself.
I don’t want to t…[Read more]

Updating this thread rather than creating a new one. There are more updates on the way. This time to the underlying operating system. Should not be a big deal.

On August 14, 2024, between 3:00 am and 4:00 am PST, we will be upgrading the operating system on your shared server from Ubuntu Focal 20.04 to Ubuntu Jammy Jellyfish 22.04. During the…

[Read more]

Have you tried  a manual reset of the trip meter?  That might realign all the numbers.(Maybe)

When I was working on it, I accidentialy slid the shaft out a little which hold the numbers for the odometer. When I finally put it back together, there was one number that wasn’t aligned with the others. Stupid me. Well I could live with one number being off a little. So I put on about 40 miles today and now they’re 3 numbers not aligned. The tri…[Read more]

I do no not have s mouse with left and right buttons. Yet I will try this.

The chassis serial # which is located on the on the top of the tunnel between the bucket seats (if you don’t have bucket seats you may have to remove the seat back rest)forward of the transaxel linkage access cover. You can then cross reference the number to those in this table. https://www.thesamba.com/vw/archives/info/bugchassisdating.php

We’ll, as I figuired, the repair guy couldn’t take it apart without destroying the bezel. I  called VDO and at one time like 15 years ago, bezels were available through VDO but not anymore.  There is no way to remove a bezel without destroying it or at least at a minimum it would end up being warped so bad it would look like hell.
I did chuck…[Read more]

I had that issue with a motorcycle fuse block many years ago. What I eventually discovered that corrosion had built up on the clips holding the glass fuse. That caused a heat build up that loosened the solder inside the fuse and it detached itself! My headlight went out at night on a curve – exciting! The fuse looked good by sight, but nothing was…[Read more]

Looks like all went well. Nothing to report. Back to driving!

Figured it out. When I looked at the fuse block originally, all the glass fuses looked good and they were. I traced the wiring as far as I could. Noticed that the wiring was a certain color for the low beam. Went to the fuse panel again, located which fuse was on that certain color wiring and removed the fuse. Swapped it out for another one. Did…[Read more]

I went with the 4 tip that you suggested, I am very happy with it. I think it delivers a good sound for a pretty cheap price. I showed the old man and he really likes it.

Getting those heater boxes out was tough with the way that the engine and the extra framing sits in my car, I decided to go with the unsafe and risky method of using a sawzaw to…[Read more]

Dale,

This isn’t going to directly answer your question…but…

Shocks should not be used to level a car or adjust ride height. The earlier term for shocks (dampers) is far more descriptive of their sole purpose. They control rebound, when your suspension is compressed.

If the car is not sitting level, there must be some other issue going on.…[Read more]

Brian,

The fuse box in my Duchess was under the dash, on the top left side of the bulkhead.

@ryanmendonca

I emailed you a couple weeks ago, using the email in your profile (I’m an admin, so I can see that info). Did you receive it?