Kall, You “suspect” accurately.  I once stored a TR6 for the winter under a “blue tarp”.  It went through several windstorms etc.  Ruined the paint job. 

That hump is likely just shaped foam rubber and you could pull the upholstery snug on the back board at the top and bottom – but I won’t/can’t guarantee that, since I’ve never even tried to install them. They came with a FiberFab kit, I think.

If you can get to San Diego, CA stop by Kline Bros. VW repair in El Cajon, CA (closer to Lakeside). They have a couple of milk crates full of VW speedo’s and parts for sale CHEAP (along with other crates of other stuff, new engines and tranny and all EMPI  and other parts). Over the years (3) I have found them all to be good guys. Be warned: this…[Read more]

My Seat back.

I have a hump in my seat back. I wonder if these would fit. I would like to have them.

Thank you for the info/link

This guy can likely repair it for you. I had him restore/rebuild the gauges for my planned dashboard.https://m.facebook.com/NorthGeorgiaSpeedometerKentT2016-01-12 09:00:43

I have the aftermarket speedometer. It’s made by VDO and is 3 1/2 inch across.

Reused the kits upper center strut. Already had the panhard rod installed so all I needed was the two lower links. I just measured and adjusted so the wheels were centered in their fenders and the wheelbase was the same side to side. Quite simple really.

And if you want more of the “old school” look, a guy on the Samba sells face decals for the 914 tach to match the older VW…[Read more]

A Porsche 914 electronic tach is identical in size to the VW speedo. I got mine on eBay 2 years ago for  under $100. There’s one in a derelict 914 in the Miramar Auto Hobby shop, Ray might sell it.

Just think, last year someone smart could have picked up a mechanically new ALL NEW ZERO miles on engine/trans everything else VW MGTD for $1,500! Glad no one jumped on it. I’ll never recoup the $3000 a year storage ($9000 total) but hey it’s ONLY money!

It’s Mrs. Emma Peel You Twit! Yes, Diana you are sooo right! It must have been the thought of you in the leather catsuit and your metallic blue Lotus Elan, both are quite exceptional!Sorry, JohnBut I did pick up today a set a new tar boards (floor insulation) and a rear engine tin to splash apron rubber gasket to keep the cooling engine air in.…[Read more]

These narrow Roadsters don’t have nearly as tall of sides as their other, larger seats. But, they’re plenty tall enough to keep your butt from sliding around. They don’t have a whole lot of foam padding, but they seem to be quite comfortable since the seat and back surfaces are suspended from the tubular frame. Luckily I have narrow hips, so…[Read more]

So I go this route if I can’t find an ’84 – ’86 SVO T5 and bell housing that already has the cable based clutch?  Sounds a lot easier to find, thanks.

[Read more]

What brand/size? The stock Bug speedos look and work great, especially when paired with a 5-inch tach.

Well-considered. They look like the’dbe great for auto-cross.

…and from what I remember you car scoots right along like a scalded cat…..a good incentive for me trying to find and install a set of Kadrons as another option (but they are getting real hard to find….)

I will put in a vote for Kadron/Solex duals.

Took a bit of time off from building shelves and pegboard panels (had built a couple workbenches earlier)…To unbox these, remove the old seats, and do a quick test fit:At 19″ wide, 26″ deep, and 31″ tall these PRP Roadster suspension racing seats will fit in there nicely. They’re sitting on universal bases from Speedway Motors. These universal…[Read more]