[benr]

This possibly is a Fiberfab Ford MIGI. Apparently, just before they were bought by CMC they had prototyped a Ford Pinto MG. It used all of the Fiberfab MIGI main fiberglass parts. The fenders were not widened nor were they extended to eliminate the front splash panel. Because of this you had to use smaller tire than on the Ford CMC/FF kits and there were other differences as well. Normally fiberfab marked all kits with some form of identification on the bulkhead above the firewall. I have only seen 2 of these Ford Fiberfab kits. And Fiberfab was molded into the bulkhead

[Author]

Posts