Vicenc, if you take 13 and the tunnel you’ll be alone. You’ll miss being in the parade with Schu’s party of three, Ed and myself. It’s quite a spectacle on 64 through Newport News into VA Beach.

Vincenc, Ed…input please. We never did 301 before. Try it or stick to 95?

😆

Personally, I preferred the diner, but you guys make the call. I’m easy.

OK, Sorry not to have you with.Ed, same pickup point as 2013? The Chevron station in Linthicum Heights at 10:30? That would make the rendezvous with Vicenc in Denver at 8:30.I have the pickup point for Gabe but he does’nt seem to be coming.Schu, I do NOT have the rendezvous point for the diner we enjoyed lunch at. If you want to do that again,…[Read more]

Paul, what are your plans?

Shipping manifest would not include the drivetrain or suspension.

Roy, you’re a strange man.

And if all those options don’t work, you can always go to coil-overs and pick your spring rate.

Add another channel and you could put up bookshelves, Paul.

Buy shorter springs with a lower spring rate.. Cutting one coil off the stock springs raises the spring rate apx. 10%. Cut two and you make it even worse.

Glue your mounting base to the hood underside, then fiberglass it in. No visible screws.

Welcome.

Just retread your post…you did bleed the master before you installed it?

How about trying the reverse bleeder, pushing the fluid from the wheels to the master cylinder.http://www.bavauto.com/fland.asp?part=2104-B&utm_source=google&utm_medium=cse&utm_term=2104-B&gclid=CNvUvYuoncgCFdcUHwodJ0sMMgWorth considering?OrOpen the bleeder, walk away and have a beer and wait til it drips.

An unusual selection, but if it’s available, what the hell. Looks like it’ll go in without too much of a fight. Will you still be able to run the same wheels?Good luck

Very nice. A lot of work there.

My fiberglass battery box piece never had that secondary flange area on it. That would have made assembly much easier.

https://tdreplica.com/Manuals/FiberFab/ford_manual_p1_P42.pdfThis is the page from the assembly manual available on the left sidebar. It shows the part you need.This part also mounts the heater and the master cylinder.These are two pictures of my installation.Behind the master cylinder is the access panel for the pedal support.Hope this is…[Read more]

https://tdreplica.com/Manuals/FiberFab/ford_manual_p1_P42.pdfThis is the page from the assembly manual available on the left sidebar. It shows the part you need.This part also mounts the heater and the master cylinder.These are two pictures of my installation.Behind the master cylinder is the access panel for the pedal support.Hope this is…[Read more]