Fired it up again today. Reset the timing. Bled the clutch again. No Air. Cannot get enough travel from the slave cylinder to fully disengage the clutch. I’m contemplating a hair brained scheme to extend the original clutch cable. Haven’t made up my mind yet. So close…

Jack, I never had to cut the hat. It was used as is. It simply bolted to the small flange on the rear cover. Drill your own holes.

I stand corrected…video works.

It’s Alive !!!

This is a 40 year old wire harness. Colors have faded. Red with blue stripe closely resembles red with green stripe. Luckily, in 1989, I had a local Ford dealer where I used to work copy the factory wiring schematic for the Pinto.

Working  from the component back to the ignition switch I was able to put the wires back where…[Read more]

Well, last week I had every intention of firing this mother up. It had other ideas. She would crank but not run. Thought maybe the wires were off 180*. Changed them. Maybe I was off one post. Changed them again. Nothing. Finally got tired of that and pulled the right side rocker cover. As I was turning it over by hand with the rocker cover and…[Read more]

Really looking forward to seeing this in person. Come on, Carlisle!

Just checked out the MGBGT build photos. That is one sweet ride. Congratulations. Good luck with the T series.

This weekend I managed to build a support along the right side of the engine to hold the catch can and heater control valve. They used to be bolted to the fiberglass side panel. The side panel will now have to be easily removable for quick access to engine bay. Also, it will be drivable without any front body panels installed.

Differential is now…[Read more]

OK, I put an off the shelf pipe elbow on the header collector only to find it hung four inches below the frame rail. I had a local shop bend a piece of pipe as tight as he could and had it “belled” so it would fit the header and eliminate the collector, making it as short as possible. It still is below the frame rail, but we’re kinda stuck with…[Read more]

Perhaps I failed to be clear. The VA Beach show will probably happen as I informed George that if it goes to Sunday, they will lose all of us. Being long term attendees that might persuade them to keep it Saturday. I know, wrong thread.

Jack, the wheel looks great.

Not a lot done this weekend as there was things to do around the house.

I did get the fan brackets removed and got the oil cooler installed. Got the plug wires on.(I hope number one is where I think it is)

Then I cleaned up the shithole my garage has become. Folded up the cherry picker and threw out a bunch of now empty boxes.

Started a…[Read more]