Perhaps I failed to be clear. The VA Beach show will probably happen as I informed George that if it goes to Sunday, they will lose all of us. Being long term attendees that might persuade them to keep it Saturday. I know, wrong thread.

Jack, the wheel looks great.

Not a lot done this weekend as there was things to do around the house.

I did get the fan brackets removed and got the oil cooler installed. Got the plug wires on.(I hope number one is where I think it is)

Then I cleaned up the shithole my garage has become. Folded up the cherry picker and threw out a bunch of now empty boxes.

Started a…[Read more]

Jack, my hood hinges are not drilled and bolted, yet. Brilliant idea. I will be doing that.

🤔🙄😁🤣

No, the rear was a bolt in. The MustangII was just a rebodied Pinto. I use three different sets of wheels. My Cragar Truspokes, 14”, push the tires right to the edge of the fenders. The 14” Fairmont wheels require a 1” spacer to clear suspension components and then fit nicely underneath. The 15” Mustang police wheels with the race tires fit rea…[Read more]

Very nice. I like the new arrangement.

Yes, Jack. Remove the three at the grille and the three at the rear all the bolts under the fender and lift. I was doing it so often and some of those nuts were a bear to get to that I went with the rivet nuts. With a small impact all those bottom bolts are removed quite quickly.

Yes, the side panels can be removed leaving the fenders in place. Rivetnuts make that real easy. As far as spark plugs, my only concern is #8, the back one on the drivers side.  Probably have to get him from underneath.

The rear is a Ford 8” from a MustangII. Once I hot rodded the Pinto motor I kept blowing those little rears apart. I already ha…[Read more]

Looking beautiful, Jack. I really like what you’ve done with the dash.

Ed, I’m still working on input.

Another rainy day to spend in the garage.

I got the cooling fan mounted.

Trimmed the wings…got it as narrow as possible…

Trial body fit…Had to whittle a bunch out of the grille shell…

Looks like it belongs in there

It’s a bit wide at the front…

Going to take it apart again and remove the upper fan mounts. We’ll try zip…[Read more]