Bill,

Very impressive!

Another rainy day to spend in the garage.

I got the cooling fan mounted.

Trimmed the wings…got it as narrow as possible…

Trial body fit…Had to whittle a bunch out of the grille shell…

Looks like it belongs in there

It’s a bit wide at the front…

Going to take it apart again and remove the upper fan mounts. We’ll try zip…[Read more]

Well it took all week to get the upper hose in place. I found the perfectly shaped hose but it was a larger diameter. I installed bushings so it would fit but the increased outer diameter made it impossible to slide on next to the bypass hose and get a clamp on it. I finally said screw it and pulled it all apart and ground part of the water pump…[Read more]

Nice!

When you end up with the little photo, go to your gallery of uploaded photos. Once there click “edit” on the thumbnail photo. This then goes to a full screen photo with an edit box. Right click and a message box should pop up. From there click on “ save photo image”. Go back to your post and right click and “paste”. I have to do that about half…[Read more]

Local rad shop supplied it. Says it’s from mid ‘60’s Mustang. Mounting tabs worked out just right.

Paul, I was wondering who would catch that.

Man, that’s tight.

I do like that the whole engine is behind the front axles.

I had to work yesterday so I only had today to get any work done. I got the temp and oil senders installed and finished their wiring. Finished the wiring on the distributor. I had to overhaul the upper steering column as the key release didn’t want to work. Don’t know what it was, but after I took it all apart and reassembled it, it worked. I put…[Read more]