Had a similiar problem with my Allison with the auto shut off not working. The Allison is a little different in that the filler is the radiator cap. Yep you guessed it. Fuel spilled down my freshly polished grille. Fortunately it wasn’t very much.
You should see the looks I get at the filling station with a gas nozzle sticking out of the radiator…[Read more]

The spinner nuts are marked “OFF” with an arrow in the direction. They also have a little ? shaped keeper to keep the spinner from backing off. This is my first set of knock off’s so I was just wondering how tight to make them. Didn’t want to over do it if you get my drift.
You would think there would be a better way to tighten these things other…[Read more]

Paul,
Just a thought but would it be better to have this topic in the MY Project area of the forum? It might make it easier for folks to find with it with the other project builds. If you think so then go ahead and move it there. newkitman40709.5078356481

I’ve thought about putting a Honda S2000 engine and transmission in an MG, but I don’t think there is enough room up front.  I know it was done in a Morgan, but that’s a larger vehicle, I believe.

The route is actually kept a secret until after race. It should be available following race on the hemmings website

I would be interested in following on my own time, some of the routes this and past Great Races have followed.  Does anyone know how I can find the routes of past races, highways, and by-ways?  This looks like it would be a lot of fun, staying off the Interstates.

 
You can have fun with before and after pictures with that one.
VW before Guinness.
VW after Guinness.
 

Perfect donor!

Okay…here’s a photo of the 71 Donor car. There are more at http://www.fotki.com/Allen1209 under the MGTD Build folder.
newkitman40709.419837963

I think I am going to take it to a friend and see what he can figure out. Talked to one guy who charges 65 an hour. Not going to happen! Wrong economy! I’ll keep on it anyway and thanks to all of you for your help!

 just follow  DO and UNDO arrow MG nuts and wings are marked I think most after market must be also DanDan R40708.8951967593

T5 would be sweet….but the clutch pedal fits?

I think they’re opposite-threaded so that driving forward will tend to tighten them.

September is looking good for this. Mid to late, I’m thinking. Greg the Delaware guy says he’s up for it (should, too, since it’s only 40-50 miles for him). 

Valves? valve springs?reaching here but I do remember a Car Craft big block chevy build from back in the day. They rigged it up nice, big cam, the works, unleashed her on the strip and the engine laid down at about 5500. Should’ve revved to about 7k, 7500. Turned out the cam mfg had shipped the wrong springs. I know, long shot. I’m still thinking…[Read more]

Don’t know about torq, but you always tighten to the rear. loosen towards front. Drivers side is not interchangable with the wifes side.

 My last 2 MGs both midget and B all I ever did was just hit them tight and never had trouble from them, they were the big nut type,,  Dan

Ifyou go to my pictures you should see a collage of wheels

Again, drinking problem I’m failing at. So let me kinow. September would probably be a good month. I’ll try to get Mrs Wobby to go ande we’ll make a trip of it. Maybe meet up along the way and hold a campout at the worlds largest campground. (Wal-Mart)

 
I breathed enough CO2 from VW heater boxes.
I’m going to do it the hard way. I want a front engined car.
Thanks for your work on the badge. It goes right next to my microcar-minicar badge. I will have a very interesting badge bar.