Once again pouring rain at registration and tech inspection. Hopefully the track will dry sometime tomorrow.

Yes, just bend the float arm.

My kit came with an original MG TD style dash mirror.

This one (note the mounting base, the picture is shown with the mirror rotated 90 degrees.

https://mossmotors.com/dash-mirror-rear-view-1

I could not see a thing, as the adjustment range was very limited.

I replaced it with this, which is ball mounted and has a very wide adjustment…[Read more]

For temporary use … a full roll of duct tape on the floor. 😉

Hawks Nest in NY state.

And any two lane blacktop!

Love the topic…same but different.

Read through this thread…

https://tdreplica.com/forums/topic/manufacturer-comparison/

Welcome aboard! And wow! That’s a heck-of-a list of questions.

At this point, I don’t believe manufacturer of the original kit weighs in too much. Build quality and condition are likely more important. that said, there is a manufacturer comparison thread here:

https://tdreplica.com/forums/topic/manufacturer-comparison/

You will find some…[Read more]

Good luck Bill.

What did Wobby say, “Ain’t nothing good ever come from racin’!”

Keep the greasy side down and the rubber on the road! I look forward to a positive report!

First, I ‘m very sorry for your loss.

Well…I hate to give pricing estimates (beauty and price are in the eye of the buyer, to coin a phrase), here goes.

I’ve recently been seeing more and more ads in the $8k to $10k range. But those are asking prices, not selling prices.

While I do hope the sellers get what they want (as that helps us all,…[Read more]

Bob
Assuming the fuel sender and gauge functioned properly in the past then the ohm ratings for both are in synch. Ie 0-90, where 0 is empty and 90 is full
If there is no indication of fuel on the gauge then check that the wire from the sender is connected to the correct tab on the gauge. Usually there is three, four or five tabs on the gauge. A +…[Read more]

Bob,

Try this Moss Motors hyperlink – https://mossmotors.com/radio-blanking-plate-set?gclid=Cj0KCQjw5NnbBRDaARIsAJP-YR8yZc5LGt1Ck4F-GZ-RUrmv9cwYO-FoBlGLCXvDUNEAx9SwPYgv9qQaAuxsEALw_wcB

This MG radio dash board cover plate assembly, to me, looks almost identical to the one in the home page photo.

I’ll also keep an eye on future comments here,…[Read more]

for research – http://jimbarrettbespokeleather.co.uk/ourshop/cat_1105011-1-Bonnet-Straps.html