I’ve got to tell you guys, the photo is the only way to go. There is no way to see that without taking off the panel. As it turned out it was the solenoid that was bad instead of the starter. Less labor, cheaper part. Thanks again for the input.

here are some pics of some parts I picked up looks, like two sets of carbs and an oil cooler will bring all with me if anyone is interested.  and finnally a picture of Ally being pulled by her big brother George

Perfect

When I mounted the wheels, the new tires would rub the front fenders (at the top/inside portion of the fenders) in sharp turns. This was caused by the width and height of the new tires. I went from 175/65R14 to 205/70R14. But as I said earlier it was a simple fix. One inch hard rubber spacers placed on the top of the coil springs. Cost about $95…[Read more]

Sarge:
That’s the look I want, tell more more about the rubbing issue
Thanks
Mel
 
 

Purchased a set of (5) wire wheels from MG magic last year. $595 plus shipping. I am satisfied with the wheels.The only thing I didn’t like was my old tires wouldn’t fit. Had to buy new tires but was able to sell the old tires and baskets for close to the cost of the new tires. Also after mounting them, found that they (tires) would rub on my…[Read more]

Gene, that’s the way I read it too. Thanks for the Ford link Ringo. I have not driven my baby for almost 2 years now. Everything is fixed, but not re-assembled. Took a major financial dive , so everything is on hold. May need a trip to Hot Springs and see your black beauty! 

Mel,Remind me when it is time to update the spreadsheet, moving you from NY to FL this summer. Goodbye snow, hello sand! Be sure to toot the horn when you pass by Greg’s in your TD James

I don’t know what I got, I’ll take a picture and post it, If you have a 34 pic 3 to trade, anything, an old pen, Tell me what you think I need. 

Bill:
I bought my car with a Florida Title but I found this link very helpful for transferring my everyday car to Florida.
http://www.flhsmv.gov/dmv/faqtitle.html
Mel
 

Gene:
I would say it’s 90% that I will go with wires over the summer.  I will be selling the baskets if I actually replace them. 
Mel
 

Richard – I might be interested in the carbs myself and might have some stuff to trade etc. – what do you need? Did they have all the stuff w/ them like riser tubes and linkage etc.?
Looking forward to meeting you and Ed in a couple of weeks.
Dale
 

I might be interested in buying your baskets if you do replace them.
I’m just North of you in Keystone Heights.

Look forward to seeing you there, Richard.

JasCochran wrote:

I shouldn’t have erased Greg’s dot so fast.  I hope the new owners registers with us so I can put a dot back.
Mel, hope you got some TD time in.
James

James:
About 2 hrs of quality time, pretty intense week getting ready for the move. 
Mel
 

If I’m decoding it correct E3ZE represents 1983 Mustang Engine

Gene,
Once you get the number this site can decode it.
http://www.classicmustang.com/decoding_part_numbers.htm
 
(James, hope you’ve been spending as much time driving it as you have under it!  )
RingoRingo40307.4926736111

Welcome to the group!  Good to have you aboard.

I shouldn’t have erased Greg’s dot so fast.  I hope the new owners registers with us so I can put a dot back.
Mel, hope you got some TD time in.
James

James,
Thanks. I’ll dig out the camera and give it a try.
Gene