Bob give Rick Drake he is a whiz when it comes to chevette motors and parts.

Here is his email address  email rdchevette@gmail.com give him a little bit to get back to you.

You can also go to. http://members.boardhost.com/Vette_Man/index.html?1513060072

There all about chevette’s.

Also welcome to the forum.

You can try this si…[Read more]

Ok a little late on this one, my spare tire mounts to a piece of metal that is bolted through the body and into two pieces of pipe that are mounted at the bottom , that allows me to open the back up by pulling two pins in the hinges on each side at the top .

Ok here is a picture of the shaft without the knob.

here is the handle i made for it.

here is picture of it together.

 here is a picture of the shifter .maybe?

The gear shift knob is held on by some splines it takes a little force but it will come off . I removed mine and made a wooden handle for it, and the emergency brake ,turn signal .

on the neutral safety switch i would check that first.

Gary welcome to the forum. We have several members that run the pinto engines, I’m sure they will chime in soon to help you out.  and again welcome to the forum.

Hello Phil,welcome to the forum.

on the top of the page you will see where it says library ,you will find all the copies of manuels  that we have ,you can down load them for free.

Pleasee share a picture of your new ride

Stephen,

You forgot excessive heat. 110 deg.  here in central Calif.

Stephen,

You forgot excessive heat. 110 deg.  hear in central Calif.

Stephen,

You forgot excessive heat. 110 deg.  hear in central Calif. </span>