Same hotel. Probably no banquet again this year cuz it’s on me and I have not had the energy to do what I’m supposed to do. Will advise.

Al, that usually is covered by the Speedster group. Once they negotiate the dates and rooms they will post. Most likely we’ll be back at the Marriott in Mechanicsburg.

Looking forward to seeing you there.

I’m signed up see you there

Don’t forget to register as a member of the Speedsters Owners.

look on http://www.thesamba.com in the classifieds under general parts click in search vdo gauges there is a guy that has what you are looking for

you can find it at MG TD Replica/Kit Car Owners Club that is the right address

I have 1  I will  PM you my ph#

I had luck on eBay when I needed one.

What feeds the hot-ignition side of your fuse box?

(By memory; grain of salt) my car has battery + running to the big starter lug, Battery – bolted to the frame and feeding a grounding buss under the dash. Fat red 10g + wire from battery to the key switch at 30, then two wires that test + go from that. The key-on + wire goes to the fuse box to…[Read more]

Weird that it broke. Why would a pulley bolt break while just driving?

Took longer than i expected to post these. Computer programs upgrade and change how everything works just as you get comfortable with them.

Anyway, the final photos of the upgrade.

The panel being finished.

The finished panel.

Didn’t turn out too bad. It’s not perfect, but it’s good enough for who it’s for.

See you in Carlisle.

On mine, the rear bow slides into a sleeve sewn into the top. There is an opening in that sleeve near each end where you take that strap and loop it over the rear bow. Then just loop it over the front bar and adjust with the buckle to where the top looks right.

We ran a new 8ga cable and everything works just fine. With everything turned on there is no smoke escaping. So on to fixing the hole in the side panel.

A trip to the local craft store supplied a Styrofoam ball.

Enlarged the hole to allow clearance for further adjustment if ever needed.

Cut a section off the ball and shaped it to resemble…[Read more]

Sorry to hear of your breakdown. I hope it goes easier than it sounds. ☹️

Congratulations on your trophy, though! 👍

Just saw the post.

Congratulations!