Gee I wish I was 54.  Happy Birthday      DanR

 Hope all had a good day and the rest of the 365 . are just as good ,we went to Dolly’s Splash Country and had a great day .  Dan

 Looks great     Dan

Will ,I guess my English teacher should have ‘learned ‘ be better . Dan

Sorry to here that, and we all will say a prayer for Ian , and a speedy recovery ,bless you all ,, Dan

That should be a lot of fun , nothing better than a Town parade ,,Dan

Wow that seems like a lot of work , time ‘n’ cash and I don’t know if is that much better than a stock power system? I have the old service brake system and have no stopping problems, you may want to check the system for a failure somewhere  I replaced the master last year simple quick,, can it be glazed drums or roters ?good luck  Dan

There many great products out there in a can but i still had my best result by wet sanding first by hand using 2000 grit to start than a buffing wheel.  Dan

Mike ,enjoy your new toy    Dan

Bebop ,,,well i guess that is why i like chevette there NO mods. to confuse me because there no after market parts outher than stock type replacement . as to the points if they make and break contact aslong as the spring tention and gap is correct they should not missfire, boat points if i remember are a little stronger in the spring , boats stay…[Read more]

Bebop ,,,well i guess that is why i like chevette there NO mods. to confuse me because there no after market parts outher than stock type replacement . as to the points if they make and break contact aslong as the spring tention and gap is correct they should not missfire, boat points if i remember are a little stronger in the spring , boats stay…[Read more]

Ray,, the manifold and carb. came from Quebec the claim is that they are more open with longer runners for better torque. the carb. is a  n.o.s. 1972 before GM had to lean them out to meet US emissions,,they are still available on line, as off road . the later carbs. had vacuum secondary throttle plates. I also changed over to hand choke .

Roy all i can say is get some emery cloth sanding each spoke one at a time a long WINTER job but that is the only way .or if you know and can get time on a sand blaster. that would faster .. I did it one spoke at a time on those cold Tennessee winter evenings.   Dan

How did they all fit in to go  Dan

Good deal  DanR

my first 3 cars were British 59 Metropolitan 56 Hillman minx California convertible ,and a Triumph Herold convertible ,and a few MGs over the years, even a fake British maker as MG in China will bring a smile  to many I have always thought mazda / ford should have bought the MG name and put it on the Mx5 Dan Dan R2012-05-22 08:08:26

I do not know about Fords but if is anything like chevette  easy but a pain in the neck at least the solinoid is on the fire wall on a ford ?? that is a place to look ,is the solinoin good ???jump it Dan

If there no fusible links in the wire , if you hot wire the starter will she turn over ? if it will turn over than i would look at the solenoid wire back to the fuse box and ignition switch . check the ground at the frame , make sure all are tight . I know it will be something simple Dan

greg ,,I would not live with  Any shake , shimmy , wobble ,,it can lead to a bad FAILER check all front end parts and I mean ALL.. Dan R

Looking at the new member posts, we went off track a bit   RADIOS started getting talked about so I figured I’d put in my 2 cents if you look in some local junk yards a factory MG “B” and Midget raido box may be what you are looking for they bolt to the floor and have a speaker and 2 rocker switches my B was metal and covered with leather look v…[Read more]